Clark's Truck Center

Refine Search 2020 INTERNATIONAL HV

Clark's Truck Center
Plattsburgh, New York, USA
Call Email Map
Quantity 1
StockNumber LH080474
Year 2020
Model HV
Condition New
HorsePower 475 hp
Engine International
EngineType A26
FuelType Diesel
EngineBrake Yes
Transmission Automatic
OverDrive Yes
Suspension Chalmers
Axle Tandem
Tires 22.5
Wheels All Aluminum
GrossVehicleWeight 66,000 lb
FrontAxleLbs 20,000 lb
RearAxleLbs 46,000 lb
DriverPosition Left Hand Drive
PICTURES ARE LIKNESS ONLY One (1) Tenco Model H345-FW Custom tilting front hitch with HEATED LED plow lights and front lift hinge remote One (1) Tenco Model FFH48-R 48” full hydraulic front post One (1) Tenco Model FRH48-R 48” full hydraulic rear tower, armature, push arms, and floating wing adaptor One (1) Tenco Model TCW-11H-39-N-R Right hand wing with 132” cutting edge, 3/16” wing skin, 32” intake height, 39 1/2” discharge height, and LED wing light One (1) Tenco Model P48R 4-8-30 trip hinge with aeon rubber compression spring One (1) Tenco Model TCB-14-T-CH-S-CH-LF 14 ft. 12M combination dump body and material spreader with SA telescopic hoist, side tilt, ¼” thick Hardox 450 floor/tailgate, and 3/16” Hardox 450 sides/front, clean side construction, Hardox 450 rated at min. 205,000 psi., stainless steel rear posts Body to Include: Air actuated tailgate, 24” cab protector, 39” sides, 51” tailgate, 12.35 cubic yard water level capacity, conveyor cover plate, body safety props, brackets for Tenco top screens (screen set not included), oval amber LED lights mounted in rear corner posts with all other Federal and NYS required lighting (LED stop/turn, LED back up, LED markers), 12” rear apron, center coal door, full grease extension set (side tilt, bearings, hoist, chain adjusters), folding grip strut ladder, interior body step, shovel bracket, body up light, mud flaps, Roll-Rite aluminum electric tarp system, steel side boards with dirt shedding top angle, rear hitch plate with pintle hook, one LED spinner light, two rear mounted LED work lights wired to cab switch, cab mounted light bar assembly with LED strobe bar, body to be painted and undercoated, color will be black. Hydraulics to Include: • Front mounted or Transmission mounted commercial intertech tandem pump with driveline and electric clutch or PTO for disengagement • Valve body to be mounted behind cab in a steel enclosure, right side • All valves and controls are to be air actuated • 40 Gallon reservoir with shut off valves mounted behind cab, left side • Muncie electronic sander control • Low hydraulic oil level sensor with automatic shutdown and an override control • Hard pipe to rear of body shall be stainless steel, all hydraulic hose shall be tough cover • Hydraulic lines to front hitch shall be stainless steel with short hoses as required • Unit is plumbed to accept and operate a reversible (power angle) front plow • Plow controls to be mounted on swinging pedestal for one or two man operation • All valves, oils, and controls for the complete operations of dump body, snowplow, and sander
Site Hosted By...
Copyright by Sandhills Publishing Company . All rights reserved. Reproduction of
material appearing on this Web site is strictly prohibited without written permission. is a registered trademark of Sandhills Publishing Company.